Please Note: This part only fits OEM No 4011981 with 6369K and FF9538 stamping on the flywheel

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation.
• Highest grade lamination materials
• Highest grade copper windings, resistant to 200 degrees Celsius.
• Connector included
• Rubber grommet included
• All product shipped are tested

Specifications of Stator:

Dimensions:
Interior diameter: 40 mm
Exterior diameter: 106 mm
Thickness: 24 mm
Length of wires stator to grommet: 45 mm
Length of wires grommet to plug: 100 mm
 

Other specifications:
Number of wires: 4
Number of plugs: 1
Number of pins: 4

Wire to wire resistance:
Alternator: Yellow to Yellow = 0.4ohms +/-20%

Specifications of Flywheel:

Dimensions:
Exterior Diameter: 167 mm
Interior Diameter: 109 mm
Interior Diameter Center Housing: 27 mm
Exterior Diameter Center Housing: 40 mm
Thickness (exterior): 54 mm
Thickness (interior): 43 mm

Before installing your new stator

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator/rectifier
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".

Before attempting to start your Polaris adjusting the air gap is necessary. Rotate the flywheel so the raised node is lined up with the pick up/pulser coil and adjust as close as possible but no less than 0.010".