Heavy Duty 65AMP Mosfet Voltage Regulator Rectifier for 2015-2018 Polaris RZR XP 1000 EPS

Important notice: This product is a direct aftermarket replacement to Polaris Recall Z-16-01-C (OEM # 2206620, 2206367, 2206473) includes a conversion harness to allow a worry free connection to older models main harness. However, for some 2016-2017 RZR models, the regulator connects directly to the main harness without the need for a conversion harness. If you need the regulator only please purchase the part number RM30421.

Dont settle for an unreliable charging system!
2012-2018 RZR 900/1000 models are well known for repeated voltage regulator failures due to manufacturing quality issues and poor placement on the vehicle.

Fix and forget the problem with RMS Labs advanced technologies!
With increased demand for an alternative solution to subpar OEM parts and unproven manufacturer recalls, we had our RMS Labs engineers tackle the problem. They came up with a permanent solution to give Polaris RZR owners confidence in their vehicles once and for all.

This STAGE 2 Kit Includes:

Meets & exceeds Polaris RZR regulator recall Z-16-01-C specifications
Improved heavy duty Polaris recommended voltage regulator housing
RMSTATOR renowned MOSFET regulation circuit for low operating temperature
Plug & Ride Design
Automotive grade stock location wiring harness with OEM-quality heavy-duty connectors

Runs cooler - Runs much cooler than the traditional Shunt voltage regulator rectifier.
Saves gas - Less load on the stator, less work, less fuel is used and you save.
Regulated energy - The power charging your battery is steadier and smooth.
Extended battery life - Extends the batterys life and cold cranking capacity.
More engine power - Removes stator load resulting in more engine power.
Optimized power - Optimize power delivery by switching the stator coils on or off.

This product is an advanced design that lowers operating temperatures for extended longevity and better performance than the OEM part.

Direct replacement to your original unit
Plug-and-play, direct fit, easy installation
The quality exceeds the OEM equipment
Improved heat sink and charging capabilities
Higher grade of electric components
All shipped products are tested

Dimensions:
Width: 110 mm
Length: 121 mm
Height: 43 mm
Fixation holes center to center: 85 mm

Other specifications:
Number of plugs: 2
Number of pins: 5
Number of wires: 5
Wires Length: 580 mm & 600 mm
Minimum Charging Voltage: 14.5 V +/- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: < 15 V
Operation Temperature: -20° to 85°

Before installing your new regulator/rectifier:
Check the AC output of the stator
Replace any burned or corroded connectors on stator and regulator/rectifier
Check and repair any melted wiring
Use hi-temp dielectric grease on all connectors

(RMS020103793_23)